Greetings!

Body Panels and Body Parts for Studebaker, Jeep, '57-'58-'59 Ford and now DODGE stamped Tailgates for both Pickups and Power Wagons are the components which Classic Enterprises now reproduces.

Our products are noted for their very good quality and are produced in gauges which are equal to, or heavier than, the original factory products. All of our products are Made In The USA within our own facility. We are continuously improving and expanding our product line.

We are currently reproducing WILLYS, Jeep, and DODGE stamped products via a special licensing agreement with CHRYSLER LLC in order to produce replacement reproductions for our customers.

We hope to be of assistance to you and hope that your project goes well.

LaMonte

Owner of

Classic Enterprises

715-537-5422

Call anytime 24/7 if you have questions or e-mail: lamonte@ClassicEnt.com

Shipping Information---

Find your vehicle type and click on Shipping Information

Unconditional Guarantee

All products are backed by our unconditional satisfaction guarantee. If you are not completely satisfied with any of our products you may return your purchase to us, within 30 days of receipt, for a full refund.

We wish you the best of luck with your restoration project!

Lamonte
Classic Enterprise

 

NEW FEATURE!

Studebaker Catalog Now Online - click here to download (16.42mb)

 

NEW PRODUCT! 

 

            

 

 

                             

             '51-'81 DODGE TAILGATE-----MADE IN THE USA

  

 

DODGE Stamped Tailgates For -           

'51-'83 DODGE Pickup Trucks & Power Wagons

Our DODGE stamped Tailgates are reproduced in 16 gauge steel as was original to the vehicle in both wide and narrow box versions. Tailgate height is 21 1/2". The DODGE lettering detail stamping is accurate in accordance to the standards of CHRYSLER LLC. An exceptional product backed by a 30 day money back guarantee.

$550.00 each plus 10%.

 

 

 

 

M-Series Cab Floors

Nicely die formed panels in #18 gauge steel as was original. Outside and toe-board edges are rolled down. A one inch roll up is formed at the rear edge of the panel. A properly shaped upward bulge is formed at the "flat" of the panel as was original. Floor Panels now include captured nuts for transmission cover hold-down bolts and side to side panel joiner (not shown).
M-Series Cab

Corners

Cab Corners and Inner Cab Corners are now available. Driver & passenger sides shown at right. Lower side & rear edges are purposely left untrimmed to allow you more flexibility in placement while fitting the panel. Do your final trim after welding is complete. (Tooling has recently been adjusted for improved panel detail).

Cab Corners

$95 each

Inner Cab Corners

$20 each

 

 

 

      

          Jeep Stamped Side Panel Repair Clips

                      

            

                                                (CJ5 Shown Above)  

      

                                       (CJ7 & Wrangler Shown Above)

                                          r

     

                         (CJ8 Scrambler Shown Above)

76-'95 CJ5-CJ7-YJ,Wrangler and CJ8 Scrambler Jeep Stamped Side Panel Repair Clips are now available as shown. Note that the upper edge of our panel is flanged to allow for a flush fit when clamping against your cut along the driver and passenger side entrances. The Jeep stamped lettering is exact in accordance to our original sample panel and approved by Chrysler LLC. The forward, upper, rear and lower edges of our panel are a duplication of the original. MADE IN THE USA in 18 gauge steel. White, black and gray lettered stickers will soon be available. Call for prices. (715-537-5422)